8
5. Remove the rubber washer, metal washer,
metal nut, metal cap and finial from the light
kit assembly. Place glass shade over the light
kit stem, secure with the rubber washer,
metal washer, metal nut, metal cap and finial
previously removed. Do not over tighten.
(Figure 19)
6. Restore power and your light kit is ready
for operations.
Installing the
Light Kit
CAUTION
To Reduce The Risk Of Electric
Shock, Disconnect The Electrical Supply
Circuit To The Fan Before Installing Light
Kit.
REMEMBER
The fan blades must already
be attached to the fan.
Your fan and light kit though pre-wired have
been disassembled at the factory to ease in
shipping. Please follow these steps to
complete the installation of your fan and
light.
TO REDUCE THE RISK OF FIRE
D O N O T E X C E E D M A X I M U M
WATTAGE RATING.
1. Remove 3 screws on the
switch
box cover.
(Figure 18)
2. While holding the light kit assembly under
your fan, snap together the wire connection
plugs. (Figure 18)
3. Carefully push all wires back into the
switch box, then install the light kit assembly
onto the switch box with the 3 screws previously
removed. Be sure to tighten all screws. (Figure
18)
4. Install 2*13W
CFL (included).. (Figure 19)
Figure 18
Switch box
CFL
Glass shade
Metal
Nut
Finial
Metal Cap
Rubber
Washer
Metal
Washer
Figure 19
Housing
Screw
Wire connection
plugs
Switch box
cover
Light kit
Switch box
MAKE SURE TO LEAVE ENOUGH SPACE
BETWEEN THE FAN PULL CHAIN AND
THE BULBS TO THE CHAIN DOESN’T RUB
AGAINST ANY OF THE BULBS. LIGHT
BULBS HAVE NO WARRANTY, CAN BE
P U R C H A S E D A T L O C A L H O M E
IMPROVEMENT STORE OR FROM OUR
SERVICE CENTER.
NOTE:
Summary of Contents for Chamblee
Page 2: ...Chamblee by Hampton Bay ...
