8 Installing the Switch Housing
.
9-Pin plugs
Switch housing
Switch housing
plate
Screws
Figure 17
NOTE
Turning power off using the fan switch is not
sufficient to prevent electric shock.
1.
2.
Remove the 1 of 3 screws from the switch housing plate and keep it for future use. Loosen the other 2 screws (Do not remove)
3.
Install the switch housing to the switch housing plate by feeding the wires from fan through the hole of switch housing, then place the switch housing key holes over the 2
screws previously loosened from the switch housing plate, turn switch housing until it locks in place at the narrow section of the key holes. Secure by tightening the 2
screws previously loosened and the one previously removed. (Fig.17)
4.
Carefully push all wires back into the switch housing, then install the switch housing cover by aligning its keyhole slots with the three screws holes and reversing switch
on the side of switch housing. Tighten the three screws securely.(Fig.17)
: Before starting installation, disconnect the power by turning off the circuit breaker or removing the fuse at fuse box.
Make wire connections: Connect the 9-pin plug from the fan to the 9-pin plug from the switch housing.(Fig.17)
Summary of Contents for CF556A-H26
Page 2: ......
