8
Assembly — Hanging the Fan (continued)
3
Setting the code on the remote:
Remove the battery cover on the back of the remote
control (G) by pressing firmly on the arrow and sliding
the cover off.
Slide the code switches to your choice of either up or
down. The factory setting is up.
Install the 23A 12V battery (BB) (included).
Replace the battery cover on the remote control (G).
Setting the code on the receiver (FF)
(Located inside top of the
motor housing.)
:
Slide the code switches on the receiver (FF) to the same
positions as set on the remote control (G).
After checking the switches, insert the receiver (FF) into the
mounting plate (A) with the flat side of the receiver facing
the ceiling.
NOTE:
The frequencies on your receiver and remote control
have been preset at the factory. Before installing the receiver,
make sure the dip switches on the receiver and remote
control are set to the same frequency. The dip switches on
the remote control are located inside the battery
compartment.
NOTE:
The battery will weaken with age and should be
replaced before leaking takes place as this will damage the
remote control. Dispose of the used battery properly and keep
the battery out of the reach of children.
NOTE:
The frequency switches on the receiving unit are
covered with a rubber cover, remove the rubber cover and
then replace it after making any changes to the frequency
switches.
Setting up the remote control
G
FF
BB
23A 12V
