25
Operation (continued)
LIGHTING (CONTINUED)
11. If igniter does not light burner:
a. Wearing heat-resistant gloves, position a long, lit match or long, lit butane lighter near the pilot housing.
b. Push and turn control knob to “ON”.
c. Remove match/lighter once burner is lit.
12. After lighting, observe the burner flame and make sure all burner ports are lit and flame height matches illustration on page 23.
Turning off
1. Turn LP gas tank valve to “CLOSED”.
2. Turn control knob to the “OFF” position.
3. Disconnect LP gas tank per “Disconnecting LP Gas Tank” section.
4. CAUTION: NEVER place cover on hot outdoor fire table.
Notices
This outdoor fire table should be thoroughly cleaned and inspected on a regular basis.
Abrasive cleaners will damage this product.
NEVER use oven cleaner to clean any part of this outdoor fire table.
Before Each Use
1. Ensure the outdoor fire table area is clear and free from any combustible materials, gasoline and other
flammable vapors and liquids.
2. Do not obstruct the flow of the combustion of LP gas and the ventilation of air.
3. Keep the ventilation opening(s) of the LP gas tank area free and clear of debris.
4. Visually check the burner flames to make sure your outdoor fire table is working properly.
5. See below for proper cleaning instructions.
6. Check all gas connections for leaks.
7. Check components for any signs of damage or rust.
8. Check for obstructions of airflow to the burner. Spiders, insects and webs can clog the burner/venturi tube. A clogged
burner/venturi tube can lead to a fire.
9. If damage to any component is detected, do NOT operate until repairs are completed.
NOTE:
A “poof” sound is normal as
the last of the LP gas is burned.
CAUTION:
If ignition does not occur in 5 seconds, turn control knob to “OFF”, wait 5 minutes, fan with a
newspaper or magazine, and repeat lighting procedure.
