Finishing the Installation
STANDARD CEILING INSTALLATION
Slide canopy up to the ceiling leaving a 1/8"clearance between the canopy and the
ceiling.
Make sure you place the wires safely into outlet box. Secure the
canopy to the hanger bracket with the four screws with your fan. Slide the canopy
ring over the canopy and tighten by turning the ring.
WARNING
MAKE SURE HOOK AT BOTTOM OF HANGER
BRACKET IS HANGER PROPERLY SEATED IN GROOVE OF HANGER
BALL BEFORE ATTACHING CANOPY TO BRACKET. FAILURE
TO PROPERLY SEAT TAB IN GROOVE COULD CAUSE DAMAGE TO
ELECTRICAL WIRING.
CLOSE-TO-CEILING INSTALLATION
Remove the fan from the tab on the hanger bracket. Secure the canopy to the hanger
bracket with four screws included with your fan.
Slide the canopy ring
over the canopy and tighten by turning the ring.
(Fig. 11)
(Fig. 12)
7.
Figure 11
Figure 12
Allow 1/8"
Clearance
Allow 1/8"
Clearance
