1
Use and Care Guide
LOW VOLTAGE OUTDOOR SPEAKER
Use and Care Guide
LOW VOLTAGE OUTDOOR SPEAKER
PACKAGE CONTENTS
A – Speaker Body x1 B – Ground Stake (6.693 in.) x1 C – Wire Connector (with 36 in. wire D- Post x1 E – M sticker x1 F – S sticker x1
attached to speaker body) x1
Assembly and Installation
1
Attaching and installing the speaker
2
Connecting the wires
NOTE
: Be sure to read the entire guide before installing the
speaker.
WARNING: Never use a hammer to insert the ground stake (B) into
the ground.
□
Screw the post (D) onto the speaker body (A).
□
Insert the wire on the wire connector (C) into the groove located on the
top of the ground stake (B).
□
Screw the ground stake (B) onto the post (D). Ensure the wire on the
wire connector (C) stays in the center of the groove of the ground stake
(B) to avoid damage to the wire.
□
Prepare a hole in the installation location. Use a tool such as a
screwdriver (not included) to prepare the installation hole to ensure
that the hole is not larger than the ground stake (B).
□
Install the speaker in the ground by pushing on the foot step (1) on the
ground stake (B). Do not push on the speaker body (A).
CAUTION: The speaker is designed to connect to a low voltage cable and
a transformer, and NOT directly to AC line voltage.
WARNING: The wire connector (C) contacts have sharp edges for piercing
the main low voltage cable. To avoid injury, do not touch the metal contacts.
CAUTION: The wire from the low voltage power unit should be 12-16 AWG
type underground Low Energy Circuit Cable.
IMPORTANT:
□
Protect the wiring by routing it in close proximity to the speaker fitting,
or next to a building structure such as a house or a deck.
□
The landscape wire and connector can also be hidden under stone or
buried under grass at a maximum depth of 6 in. (15.24 cm).
□
Do not install the speaker within 10 ft. of a pool, spa, or fountain,
or any location that may collect water.
□
Do not submerge the speaker in water.
□
Place the wire connector (C) on opposite sides of the low voltage cable
(not included) from the transformer (not included) where the speaker will
be located.
□
Align and fit the main low voltage cable vertically to the slot of the wire
connector (C).
□
Press the wire connector (C) together until it is locked around the main low
voltage cable. The pre-set prongs will pierce the cable insulation and
establish contact with the electrical wire inside.
□
Once the wire connector (C) is in place, it is recommended to wrap it with
electrical tape (not included).
□
Low voltage lights can also be connected on the same main low voltage
cable from the transformer.
□
After the speaker (and any low voltage lights) are installed, turn on the
transformer.
Item #1003 317 016
Model #B0029RA-2
