11. Installing the Light Kit
Figure 18
Figure 19
Light kit
Connection plugs
Mounting plate
Screws
Bulbs
Glass shade
Decorative nut
Decorative cover
Rubber washer
Nut
REMEMBER:
To disconnect the power. The fan
blades must be already attached to the fan.
Step 1.
Remove 1 of the 3 screws from the mounting
plate and keep it for future use. Loosen the other 2
screws. (Do not remove)
Step 2.
Raise and hold the light kit close to the
mounting plate and proceed to do the wire
connections. Connect the white wire connectors
from the light kit and fan, follow the same procedure
with the black wire connectors. (Fig. 18)
Step 3.
Tuck connections neatly into mounting plate,
Place the key holes on the light kit over the 2 screws
previously loosened from the mounting plate, turn
light plate until it locks in place at the narrow section
of the key holes. Secure by tightening the 2 screws
previously loosened and the one previously
removed.(Fig. 18)
Step 4.
Install 3 x 40W (Max.)
bulbs
(included). (Fig. 19)
Step 5.
Remove the rubber washer, nut and
decorative nut from the light kit. Raise the glass
shade up against the light kit, Place the rubber
washer and nut on the top over the stem and turn it
clockwise until it locks up against the glass shade.
Do not overtighten. (Fig. 19)
candelabra
NOTE:
Light bulbs have no warranty, can
be purchased at local light bulb specialty
store or from our service center.
Step 6.
Raise the decorative cover and
decorative nut against the glass shade and
secure it to the stem by turning the final
clockwise until snug. Do not overtighten.
(Fig. 19)
