Light holder
40W bulbs
Glass shade
Glass cap
Decorative nut
Metal plate
Figure 15
NOTE
: Before starting installation, disconnect
the power by turning off the circuit breaker or
removing the fuse at fuse box.
1. Remove 1 of the 3 screws from the
mounting ring and loosen the other 2 screws.
(Do not remove)
2. Raise and hold the light plate close to the
mounting ring and proceed to do the wire
connections. Connect the white wire
connectors from the light plate and fan,
follow the same procedure with the black
and blue wire connectors. (Fig. 14)
3. Carefully push all wires back into the
mounting ring, then install the light plate
onto the mounting ring with the 2 screws
previously loosened and the one previously
removed. Be sure to tighten all screws. (Fig.
14)
4. Loosen the 3 screws from the light plate.
5. Install the light holder onto the light plate
with the 3 screws previously loosened. Be
sure to tighten all screws. (Fig. 14)
6. Install 3x40W (MAX.) candelabra bulbs
(provided).
7. Raise the glass shade up against the light
holder, place the metal plate on the top over
the light holder and turn it clockwise until it
locks up against the light holder.
Do not
over tighten.
(Fig. 15)
8. Place the glass shade over the light holder
and secure it with the glass cap and
decorative nut.(Fig. 15)
9. Installing the light kit
Mounting ring
Screws
Screws
Connection plug
Light plate
Light holder
Figure 14
NOTE:
Light bulbs have no warranty,
can be purchased at local light bulb
specialty store or from our service
center.
