13
HAMPTONBAY.COM
Please contact 1-855-HD-HAMPTON for further assistance.
Assembly - Attaching the Lights
Installing the bulbs and shatter
resistant shades
2
□
Place the shatter resistant shade (I) into the light kit
assembly (E), aligning the three flat areas on the top flange of
the shatter resistant shade (I) with the three raised dimples
in the light kit assembly (E). Turn the shatter resistant shade
(I) clockwise until it stops. Repeat for the remaining shades.
□
With power off, install the three flourescent bulbs (J)
(Max.14W. included) into the light sockets.
□
Attach the pull chain extensions (FF) to the fan switch and
light switch pull chains.
CAUTION:
Make sure the power is off before attaching or
removing the shatter resistant shades.
WARNING:
Over lamping the light kit will result in the lights
shutting down until the proper wattage of bulbs are installed.
Reset the lights by turning off the light kit, replace the bulbs
with the correct wattage bulbs, and turn the light kit back on.
WARNING:
Allow the shatter resistant shades to cool
completely before removing.
FF
D
I
J
Turn on the power and check the operation of the fan. The fan pull
chain controls the fan speed as follows:
1 pull - High, 2 pulls - Medium, 3 pulls - Low, 4 pulls - off
The appropriate speed settings for warm or cool weather depends on
factors such as the room size, ceiling height, and number of fans.
The slide switch (SS) controls the direction of the blades: forward
(switch left) or reverse (switch right).
A. Warm weather - (Forward) A downward airflow creates a cooling
effect. This allows you to set your air conditioner on a higher setting
without affecting your comfort.
B. Cool weather - (Reverse) An upward airflow moves warm air off of the
ceiling. This allows you to set your heating unit on a lower setting
without affecting your comfort.
NOTE:
Wait for the fan to stop before reversing the direction of the
blade rotation.
SS
SS
Operation
OPERATING YOUR FAN
A. Warm Weather
B. Cool Weather
