4
installation 1
WarninG:
RISK OF ELECTRIC SHOCK. Ensure the electricity to the wires you are working on is shut off. Either remove the fuse or turn off
the circuit breaker before removing the existing light fixture or installing the new one.
With power disconnected to the electrical box, remove the existing fixture. Make a sketch of how the current fixture is wired (by wire color)
or mark the wires with masking tape and a pencil so you will know how to properly reconnect the wires to the new LED light fixture.
1
Open the fixture
□
Open the lens (A) from the fixture base (B) by screwdriver,
and disconnect the connector between PCB and the driver.
2
Positioning and drilling
□
Mark 4 holes position and drill holes using
Φ
0.26in.(6.5mm),
insert the drywall anchors (AA) into the holes.
note:
do not need drill hole on wooden surface.
3
Before fixing the fixture base (B)
□
Put the Gasket (EE) on the back of fixture base (B).
□
Drill 4 holes through the 4 markpoints of fixture base (B),
connect the AC wires and the driver wires by wire nut (BB).
note:
AC wires should go through one of the 5
conduit entry holes on the fixture base (B)
.
4
Assemble the lamp cover
□
Aligh the holes on the fixture base (B) with the holes in the
wall, and drill fix screws (CC) into the holes, lastly, silicone
sealant (not included) around the 4 holes.
□
Assemble the lens (A) with the fixture base (B) after
connecting the connector of PCB and driver. Then tighten
with lens screws.
□
Apply silicone sealant (not included) between the fixture
and the wall.
A
B
Connector
7.48in. (190mm)
4.33in. (110mm)
AA
Conduit entry holes
Mark points
Conduit
(not included)
BB
B
B
B
CC
Lens screw
Silicone sealant
(not included)
A
EE
Φ
0.26in. (6.5mm)
Φ
0.18in.
(4.5mm)
Connector
