9
Attaching the Switch
Housing Assembly
Remove the 1 of 3 screws from the mounting
ring and loosen the other 2 screws.
(Do not
remove)
While holding the switch housing assembly
under your fan, pass the wire connection plug
from the motor through the switch housing
assembly. (Fig. 18)
Place the key holes on the switch housing over
the 2 screws previously loosened from the
mounting ring, turn switch housing until it
locks in place at the narrow section of the key
holes. Secure by tightening the 2 screws
previously loosened and the one previously
removed (Fig. 18).
Snap the wire connection plug from motor
and switch housing together. (Fig. 18)
1.
2.
3.
4.
Switch Housing
Assembly
Wire Connection Plugs
Mounting Ring
Screws
Figure 18
