J
RR
11
Assembly — Installing the Light Kit
12
Attaching the light kit to
the light kit mounting plate
K
SS
TT
CC
G
J
UU
VV
WW
NOTE:
If you do not wish to install the light kit, skip steps 12
through 13 and proceed to step 14.
Attaching the light kit mounting
plate to the mounting ring
□
Remove one of the three light kit mounting plate
screws (RR) from the mounting ring (QQ) and loosen
the other two screws. (Do not remove.)
□
Place the key holes in the light kit mounting plate (J)
over the two screws (RR) previously loosened from
the mounting ring (QQ). Turn the light kit mounting
plate (J) until the light kit mounting plate (J) locks in
place at the narrow section of the key holes.
□
Securely tighten the two light kit mounting plate
screws (RR) previously loosened and the one (RR)
previously removed.
CAUTION:
Before starting installation, disconnect the
power by turning off the circuit breaker or removing the fuse
at the fuse box. Turning power off using the fan switch is not
sufficient to prevent electric shock.
□
Remove four light kit mounting screws (SS) from the
light kit mounting plate (J).
□
While holding the light kit assembly (K) under the fan,
snap together the wire connection plugs (TT).
□
Carefully push all wires back into the switch housing.
Install the light kit assembly (K) onto the light kit
mounting plate (J) with the four light kit mounting
screws (SS) previously removed. Be sure to tighten
all screws.
□
Install the 9W LED bulbs (CC) (included).
□
Remove the decorative nut (WW), glass cap (VV) and
the metal nut (UU) from the light kit assembly (K).
17
HAMPTONBAY.COM
Please contact 1-855-HD-HAMPTON for further assistance.
