4
AA
installation
warninG:
RISK OF ELECTRIC SHOCK. Ensure the electricity to the wires you are working on is shut off. Either remove the fuse or turn off the
circuit breaker before removing the existing light fixture or installing the new one.
With the power disconnected to the electrical box, remove the existing fixture. Make a sketch of how the current fixture is wired (by wire
color) or mark the wires with masking tape and a pencil so you will know how to properly reconnect the wires to the new LED light fixture.
noTe:
Two people are recommended for the installation of this light fixture.
1
Attaching the electrical
box screws to the
electrical outlet box
□
Attach the electrical box screws (AA)
to the electrical outlet box, but do not
tighten fully.
2
Marking the mounting surface for installation
□
Position the mounting bracket (B) over the electrical outlet box, allowing the
heads of the electrical box screws (AA) to come through the large ends of the
keyholes.
□
Turn the mounting bracket (B) so the heads of the electrical box screws (AA)
slide into the narrow portion of the keyholes.
□
Position the mounting bracket (B) on the mounting surface in the desired
position for the fixture body (A).
□
Tighten the electrical box screws (AA) temporarily so the mounting
bracket (B) is flush to the mounting surface.
□
Use a pencil to mark the ceiling with the positions of the four mounting holes in
the mounting bracket (B).
Mounting to drywall
B
Mounting
Holes
AA
Keyholes
