23
Care
and
Cleaning
A clean fan provides better service. Disconnect the power supply and clean the fan as listed below:
TO CLEAN GRILL:
Use a mild detergent, such as dishwashing liquid, and a soft cloth. DO NOT use abrasive cloths, steel wool pads or scouring powders.
o
TO CLEAN FAN ASSEMBLY:
Unplug motor cord from receptacle. To remove motor plate, find the single tab on the motor plate (located next to the receptacle).
Push up rear motor plate tab while pushing out on the side of the housing or insert a screwdriver into the slot in the housing (next
to tab) and twist screwdriver. Gently vacuum fan, motor and interior of housing.
o
METAL AND ELECTRICAL PARTS SHOULD NEVER BE IMMERSED IN WATER.
o
MAINTENANCE: The motor is permanently lubricated and never needs oiling. If the motor bearings are making excessive or unusual
noises, replace the motor with the exact service motor. You should replace the impeller at the same time.
o
Troubleshooting
Specifications
Model No.
80213
Air direction
80
cfm
Voltage
120 V
Hertz
60
Hz
Duct diameter
4
in
. (
10.16
cm
)
Noise
2
.
0
Sone
Power consumption (watts)
23 W
Speed
1250 rpm
Air deliver at 0.1" WG
80
cfm
Weight
11
.
9
lbs
. (
5
.
4
kg
)
Problem
Solution
The fan does not come on
.
Hampton Bay ventilation fans are extremely quiet. To confirm that the fan is running, place your hand near
the vents to feel the air movement.
Fan is noisy
.
Turn power on, replace fuse, or reset breaker.
Check all plug connections to be sure they are secure.
Check the wiring to make sure it matches the wiring diagram.
Check and tighten all fasteners.
Check the glass to make sure it is secure.
Light does not come on
.
Replace the light bulb with a new bulb.
Turn power on, replace fuse, or reset breaker.
Check all plug connections to be sure they are secure.
Check the wiring to make sure it matches the wiring diagram.
Check the flapper to make sure it moves freely.
WARNING:
Make sure the power is off at the electrical panel box before you attempt any repairs. Refer to the section Safety Information.
WARNING:
Make sure the power is off at the electrical panel box before you attempt any repairs. Refer to the section Safety Information.
