10
Lighting a Fire
WARNING:
If these instructions are not followed exactly,
a fire or explosion may result causing property damage,
personal injury or loss of life.
1. Make sure the control knob is in the “OFF” position. Open the
tank valve all the way.
2. Push in the igniter button. You will hear a slight clicking
sound. With the igniter button pushed in, push and turn the
control knob to the “ON” position. The fire should light within
a few seconds. Once the flame is lit, release the igniter button
and continue to hold the control knob in for 10 to 15 seconds.
Release the control knob. The control knob should pop back
out and then remain lit. If the fire does not light, turn the knob
to the “OFF” position and wait five (5) minutes before trying
again.
3. To turn down the flame, push the control knob in slightly and
turn to Medium (medium flame) or Low (small flame).
4. To shut down the fire pit, turn the control knob to the “OFF”
position and turn off the tank valve.
( 1.5V ) AAA
BATTERY COMARTMENT
INSTALL (-) SIDE FIRST
ON
HIGH
OFF
IGNITOR
MEDIUM
LOW
PATENT PENDING
PATIO
GLOW
FLAME APPEARANCE
Ensure the flame appears as this image shows:
Care and Cleaning
To clean the burner, use a soft brush after the burner has cooled completely. Never use a vacuum cleaner on the burner. It is recommended
that the fire pit be stored indoors during the winter if it will be subjected to freezing temperatures. The LP cylinder must be disconnected
and removed from the appliance before the appliance can be stored indoors.
