45
"
!
#
"
!
#
Saw-Spindle Moulder
B3 / B3 e-classic
Note: The saw blade only operates if the break switch inside the machine frame has not been activated by
the locking system: the sliding cover is closed
• The sliding cover and spindle door are closed and the safety system is in the centre position
Making adjustments and preparations
1.
Tilt the circular saw into a 90° position
Move the circular saw right up to the top
2.
Switch the machine off and ensure that it cannot be
switched on again.
3.
Push the lock downwards.
4.
Slide the sliding table to the right until it reaches its
limit.
5.
Slide the sliding cover to the left until it reaches the
stop.
!
Sliding table
"
sliding cover
#
Lock system
8.9 Tool change
8.9.1 Preparing to change tooling
Fig. 8-17: Preparing to change tooling
8.9.2 Preparing the machine to operate
Fig. 8-18: Prepare the machine to operate
1.
Slide the sliding cover to the right until it reaches the
stop.
2.
Move the sliding table to the left.
3.
Push the lock to the top.
4.
Switch machine on
!
Sliding table
"
sliding cover
#
Lock system
