HK-61902
USER GUIDE
Action
LED
Turn on the device
Push the button
Red and Green LED´s light up simultaneously
Reset the device after a test
Push the button
Red LED is turned off, Green LED starts
fl
ashing
Turn off the device
Push the button
Green LED is turned off
LED indications
Emulator is operational (battery ok)
Green LED is
fl
ashing
Output has been activated
Green LED is turned off, Red LED is
fl
ashing
Low battery voltage on Emulator
Red and Green LED will give alternating
fl
ashes and the
device
will
be
switched
off
again.
FIRST TIME OF USE
•
Open the Emulator enclosure by gently twisting a screwdriver in the slot at the side of the enclosure.
•
Insert a CR2032 battery in the battery holder.
•
Attach two connection wires to the terminals on the Emulator. (Do not use to much torque on the terminal screws)
NORMAL USE
•
Open the enclosure and push the pushbutton on the circuit board to switch on the Emulator.
The red and the green LED on the circuit board shall light up simultaneously when the pushbutton is pushed. If the battery is ok the green
LED will start fl ashing green and the device is ready to be used.
•
Attach two connection wires to the terminals on the Emulator. (Do not use to much torque on the terminal screws)
•
To test the system, connect the wires to the Electronic Remote Release System ERU output. (The polarity is not important)
TEST THE ELECTRONIC REMOTE RELEASE SYSTEM
•
Activate the output on the Electronic Remote Release System and check that the fl ashing green LED is turned off and that the red LED
has started to fl ash.
•
If the green LED is turned off and the red LED are turned on (fl ashing) the ERU output signal from the Electronic Remote Release System
has been ok.
NB! The ERU Emulator does not break the circuit when it is activated and it will be detected as an installed ERU by the ERRS system
even if it has turned from green to red.
REPEAT THE TEST
Push the pushbutton on the circuit to reset the Emulator. When the green LED is fl ashing, the device is ready to be used again.
TO TURN OFF THE EMULATOR
•
If a test has been performed, the Emulator has to be reset to a fl ashing green status.
•
Then again push the pushbutton and the device will be turned off and the LED´s will stop fl ashing.
The device will turn itself off automatically 30 minutes from the last push on the pushbutton.
The DIP switches are not used in this application and shall be in off position.
