by-laws have been followed during installation.
See separate installation guide.
All firebox liner panels and throat plate are in
place.
That the chimney draw has been checked
and is within specification. With the chimney
warm, the draught should be between 1-2
mm water gauge or 0.1 to 0.2 mbar.
A Carbon Monoxide detector is correctly
installed in the same room as the appliance.
WARNING:
An over drawing chimney can
cause over firing, resulting in damage to the
appliance.
Ensure that you have read and understood
these instructions before lighting the fire.
Always wear suitable protective fire gloves
when refuelling your stove, such as the Arada
glove supplied with your stove.
AIR INLET CONTROLS
If you have a DEFRA stove model please refer
to page 6 for instructions on operating the air
controls.
Your stove has two air inlet controls. These may
be located either on the stove body or the
door.
The primary air inlet providing under draught
to the base of the fire chamber and the
airwash system (secondary air) providing
overdraught. The exact controls may differ from
those illustrated in this manual but will work in
the same way.
PRIMARY AIR
Air enters the appliance through the control on
the bottom of the fire door. Your stove has a single
control knob which slides left to right. Sliding the
knob to the right, see Fig. 1. will increase the
amount of air intake to the stove.
To decrease, push the slider to the left, see Fig. 2.
AIRWASH SYSTEM / SECONDARY AIR
The airwash system is located either at the top
of / above the fire door. Sliding the control knob
to the
RIGHT
as far as it will go, achieves the fully
open position, see Fig. 3.
4
USER GUIDE
Hamlet User Guide
Fig. 1. Fully Open Position
Fig. 3. Airwash Fully Open Position
Fig. 2. Fully Closed Position
