Document #101-0038
3
11/08/06
I. INSTALLATION
INSTALLATION OF ENCLOSURE
1.
Unlock , open door and turn off power to the Autocashier.
2.
Turn off main breaker for Autocashier.
3.
Remove the four knockouts from the mounting holes in back of the Autocashier cabinet.
4.
Loosen the conduit connectors.
5.
Loosen, but DO NOT REMOVE THE ANCHOR BOLTS securing the Autocashier to the base.
The Autocashier becomes top heavy when the door is open. IF THE ANCHOR
BOLTS ARE REMOVED ALL AT ONCE, THE UNIT MAY FALL OVER
CAUSING INJURY
6.
Remove the two anchor bolts on the Right Side of the bottom of the Autocashier. LEAVE THE
ANCHOR BOLTS ON THE LEFT SIE IN PLACE.
7.
Lift up the right side of the Autocashier approximately 1/2”. Slide the bottom flange of the Right
Side Panel (61-2102) under the Autocashier. Make sure the front flange of the Right Side Panel
(61-2102) is in front of the of the flange that is already part of the Autocashier. Maneuver the Right
Side Panel (61-2102) and the Autocashier cabinet around until all the holes line up. The two in the
bottom and the two in the back.
8.
Reinstall the two right anchor bolts, but do not tighten completely.
9.
Repeat steps 6, 7 and 8 for the Left Side Panel (61-2101). REMOVE ONLY THE LEFT SIDE
ANCHOR BOLTS.
10.
Place the Light Bracket (05-0013) on top of the two Side Panels and Autocashier. Making sure that
the Side Panels set outside of the small tabs located at the front, lower outside edges of the Light
Bracket (05-0013).
11.
Install the four 10-24 x 3/8 screws (90-0148) to secure the Light Bracket (05-0013) to the Side
Panels. Make sure the edges of the Light Bracket (05-0013) are flush with the outside surfaces of
the Side Panels before tightening.
12.
Run the electrical conduit up from the conduit hole in the back of the Autocashier to the utility box
intended for the fluorescent lamp wiring. Follow all applicable local codes. It is recommended to use
a separate breaker for the fluorescent lamp so that it can be turned off during the day.
13.
Remove the four 1/4 x 20 nuts (90-0331) and washers (90-0429) from the studs on the Back
Panel (61-2103)