Hamilton Safe Company
Step #5:
Cut or disconnect wires going to motor. Remove three screws that hold the motor bracket to the frame and
remove the motor assembly.
Step #6:
Cut or disconnect wires from terminal strip that lead to switch on hopper block.
Remove two screws that hold the top cover over the hopper gear at the left end of the hopper. Then remove the four
screws that hold the hopper block to the frame. Turn the hopper so that the rectangle notch, on the right side of the
hopper, is straight out to the front of the night head and with a long 3/16" hex key wrench remove one screw on axle.
Turn the hopper so that the rectangle notch on the right side is straight out the back and remove the hopper.
Page 4 of 9
