Document #101-0163
9
1/10/06
Token Vendor
Installation
1.
Make sure there is no power in the six wires run to the Hamilton Token Vendor.
2.
Open up cabinet and unplug and remove hopper and set aside.
3.
Using a Phillips head screwdriver, and a 7/16" socket wrench remove four #1/4-20 nuts
lockwashers and screws, (these #1/4 nuts, lockwashers and screws are used for shipping purposes
only) this will allow you to remove the hopper plate.
4.
Place cabinet on base and run wires up through conduit hole in bottom of cabinet.
5.
Connect wires to Dual Terminal strip as shown on diagram.(page 9)
Note: For proper wire connections consult a certified electrician.
6.
Place hopper plate back in position and tighten to base using four # 5/16-18 screws, with ¼” hex
key. (page 10)
7.
Replace hopper in machine and plug in the hopper.
L1
WHITE
WHITE/RED
HOPPER
RED
10
9
8
7
6
1
2
3
4
5
TO HOPPER
DROP
PURPLE
HOPPER RETURN
GREEN
GROUND
BLACK
L2
10
9
8
7
6
1
2
3
4
5
WHITE/RED
RED
PURPLE
WHITE
GREEN
BLACK
DROP
HOPPER
HOPPER RETURN
L1
GROUND
L2
FROM ACW
TERMINAL STRIP
