Page 3
13.
Insert the two horizontal
mounts onto the supporting
poles. Note: The mount with
adjustable screw(see screw
table H) should go on the
bottom. Screw(see screw
table G) the top mount to
desired height from A to F.
Adjust the bottom mount
height according to the TV
screw position as shown.
12.
Insert the two supporting poles onto the holes on top shelf. Wire
holes can face inside or outside.
11.
Put the top section assembly over the bottom section at desired
height. Tighten the top section onto the bottom with two screws
(see screw table J) on each leg as shown.
Top horizontal mount
Bottom horizontal mount
17.
Use the appropriate security screws needed (M4, M5, M6 or M8,
see screw table A,B,C or D) to fasten the flat panel TV onto the
horizontal mounts as shown.
14.
Tighten the two supporting poles onto the top shelf with two
security screws as shown (see screw table F).
16
.
Pull out shelf assembly
Adjust the length of the
pull out shelf as shown
on Fig. A by loosing the
screws and tightening
again so that the width
of the pull out shelf
matches the width of
the cart. Tighten the pull
out shelf to the cart with
the screws (see screw
table J) as shown on Fig. A
and Fig. B.
Fig. A
Fig. B
15.
Electrical bracket assembly instruction
A. Push power cord into cord winder bracket.
B. Attach electrical bracket to back side of top shelf with two nuts
and bolts (see screw table E). Tighten nuts and bolts securely.
Wrap power cord around wings of the bracket.
Electrical
bracket wings
Bolts
Nuts
WARNING:
Please keep the
TV mounting screws A,B,C & D
and the L keys in a secure
location as they may be required
for use with the flat panel TV at
a later time.
If any parts or hardware are missing or damaged,
Do Not
Return
the unit to your dealer. Call the
HamiltonBuhl
help line at
(800)742-5672 for immediate parts replacement.
A Division of Vcom
IMC
80 Little Falls Road, Fairfield, NJ 07004, USA
1-800-631-0868 • www.HamiltonBuhl.com