4
POWER SOURCE
BATTERY INSTALLATION
Four (4) “AA” size batteries can be used to power this
unit. Install as follows:
1. Open the battery door by pushing in on the tab,
then removing the door.
2. Insert four (4) “AA” batteries as shown. Alkaline
batteries are recommended for the longest play time.
3. Replace the battery door.
NOTES:
The batteries are used for power when the AC adapter is disconnected
or there is a power failure.
The battery indicator will blink when the batteries are low and need
replacing.
Follow these precautions when using batteries in this device:
1. Warning-Danger of explosion if batteries are installed incorrectly.
2. Use only the size and type of battery specified.
3. Be sure to follow the correct polarity when installing the batteries, as indicated in
the Battery Compartment. A reversed battery may cause damage to the device.
4. Do not mix different types of batteries together (e.g. Alkaline, Rechargeable and
Carbon-zinc) or old batteries with fresh ones.
5. If the device will not be used for a long period of time, remove the batteries to
prevent damage or injury from possible battery leakage.
6. Do not try to recharge a battery that is not intended to be recharged; it can
overheat and rupture. (Follow battery manufacturer’s directions.)
AC CONNECTION
Insert the small end of the AC adaptor into
the DC IN Jack (located on the rear of the
unit). Connect the other end to a wall outlet
providing 100-240V AC, 50/60 Hz.
NOTES:
• Disconnect both the DC IN plug and the
AC plug when not in use.
• Use only the supplied AC adaptor with the following specs: 100-240V AC,
50/60 Hz In; 3.5A, 5V DC Out
BATTERY PRECAUTIONS
Summary of Contents for ip3
Page 1: ...ip3 Learning Center USER S MANUAL...
Page 2: ......
