7
1.
Remove dispenser assembly cap by
rotating coun-
terclockwise.
2.
Wash dispenser and parts in hot,
soapy water. Rinse and dry
thoroughly. Do not soak.
NOTE:
Do not remove seal rings
from adaptor.
3.
Reassemble plunger inside of
dispenser body and rotate cap
clockwise until tight.
Troubleshooting
PROBLEM
Blender leaks.
Ice not crushed.
Does not
blend well.
Does not dispense.
Dispenser leaks.
Cannot remove
cutting assembly.
PROBABLE CAUSE
• Tighten cutting assembly on jar.
• Make sure gasket is in place on cutting assembly.
• Make sure gasket is not damaged. If damaged, please
call our toll-free customer service number to order a
replacement.
• Make sure lid with filler cap is pushed down tightly on
jar.
• See ice crushing instructions in “Blending Specific
Foods” section.
•
Make sure enough liquid has been added. A
minimum of 10 ounces (300 ml) is recommended.
• Make sure blender is ON.
• Make sure seal rings are in place on dispenser
adapter.
• Tighten dispenser cap (located above dispenser body).
• Loosen collar by holding jar and turning cutting
assembly counterclockwise.
Dispenser
Assembly
Cap
Dispenser
Assembly
Body
Adaptor
Seal Rings
Optional Cleaning
Plunger
840155503 ENv01.qxd:840153700 ENv01.qxd 7/9/10 8:37 AM Page 7
Meijer.com
