47
Subject to change without notice
STOP
However, if you now look at the Hz – display you will
notice that there was a 7 to the right of the decimal
point, the cursor will come below the same 7 in the
kHz – display.
Input via the menu pushbutton group
Go to the basic menu using the keyboard
so you will get the
following display:
Fr. 1.0000000 kHz
Sin Tri Sqr -->
e
f
g
h
Push button [1] of the keyboard
and enter the
HINT
value shown by pushing button kHz/mV.“
Push button [FREQ] inorder to activate the frequencefunction.
The display will show the following:
Fr: 1.0000000 kHz
- v a l + < c u r >
Below the display there are the menu buttons
. The buttons
a
and
b
correspond with the display function – val +. With
the two buttons below the – and + symbols the value indicated
by the cursor can be decreased resp. increased. The buttons
c
and
d
belong to the cursor function
<
cur
>
and move the
cursor left or right.
In the following example the value 102.56 kHz is entered:
FR: _1.0000000 kHz
-val+ < c u r >
a
b
d
c
Push the button
c
in button group
below the symbol
<
and
move the cursor 2 positions to the left.
FR: 101.0000000 kHz
-val+ < c u r >
a
b
d
c
Now push the button
b
below the once. The display
will now show:
FR: 102.0000000 kHz
-val+ < c u r >
a
b
d
c
Now move the cursor one position to the right. Use button
to select the 5. Move the cursor again one position to the right
and use button
b
to select 6. This will yield the desired dis-
play.
FR: 102.5600000 kHz
-val+ < c u r >
a
b
d
c
STOP
H resp. – depressed will automatically
increase resp. decrease the value. It is hence un-
necessary to repeat pushing these buttons in order
to increase or decrease. This allows a fast change
of values. Of course, the amount of increment resp.
decrement is determined by the position of the
cursor.
“You can enter 150 kHz just by remaining e.g. in the
1/100
th
position, but it will cost your time. Moving
the cursor by 3 positions to the left in order
HINT
to enter the 5 will speed matters up.“
Input via the knob
Select the basic menu using the button group
so you get the
following display:
Fr. 1.0000000 kHz
Sin Tri Sqr -->
e
f
g
h
3
2
4
5 6
1
Push button [FREQ]
e
in order to call up the frequency function,
the display will show:
Fr: 1.0000000 kHz
- v a l + < c u r >
Below the display there is the button group
. With the but-
tons
c
and
d
,associated with the display function
<
cur
>
,
the cursor can be moved. As an example the value 102.56 kHz
shall be entered:
FR: _1.0000000 kHz
-val+ < c u r >
a
b
d
c
Push button
c
of group
below the symbol
<
and move the
cursor 2 positions to the right. Now turn the knob
softly
clockwise until you get this display:
FR: 101.0000000 kHz
-val+ < c u r >
a
b
d
c
Should you have gone too far turning the knob
HINT
counterclockwise will get you there.
S t r u c t u r e a n d u s i n g o f t h e m e n u s