C11440-42U/C11440-42U01 Instruction manual_Ver.1.1
7. CONNECTION
7-1 CONNECTING OF CABLES
Refer to the figure when connecting the various cables.
Camera
(Rear)
Figure 7-1
•
When you connect cables, turn off the power supply of the camera and the peripheral devices.
•
If you use the adjuster pole and the base plate, see each installation manual.
CAUT
ION
•
Do not place the rear panel of the camera, which connectors are located,
to be at the bottom (Do not block ventilation openings.).
①
AC adaptor
This is the cord to supply a power supply. Use the accessory AC adaptor.
②
USB 3.0 interface cable (Option)
This is the cable to connect the USB 3.0 interface connector of the camera and the USB 3.0
interface connector on the computer.
Note
•
Hamamatsu recommends A12046-03 optional USB 3.0 interface cable for this
camera. The camera complies with EMC direction with using A12467-03 Camera
Link interface cable. Be careful that the camera with other interface cable may not
fulfill the EMC directive requirements.
Computer
①
AC adaptor
②
USB 3.0 Interface cable
USB 3.0 Interface board
13
