Hama X-Arm 49570, Manual

Page: 16 / 47

5. Setting the TV size on the X-arm™ bracket
To prevent injuries and damage to the device, it is important to adjust the X-arm™ bracket to the TV width. The movement radius of the
bracket is limited according to the TV size set on the X-arm™ bracket.
5-1. Plug the power cable in and connect the X-arm
TM
bracket to an earthed power source.
The X-arm™ power cable is equipped with an earthing connector. It must be plugged into a
suitable socket that corresponds to all local installation and earthing regulations and
ordinances. More earthing information is located at the beginning of these instructions.
5-2. Switch the Power toggle switch on (position 1).
5-3. Measure the entire width of the TV, including
any integrated side speakers. To set the TV size
on the X-arm TM bracket, do not use the screen
size specifi ed by the manufacturer.
5-4. Insert the provided plastic pin into the opening marked Selection, and press the button until
the TV size code matches the width of your TV according to the table below.
Code
Total TV width
C1 102–112 cm
C2 114–122 cm
C3 124–140 cm
C4 142–155 cm
5-5. Hold the black Selection button pressed down until the TV size
code no longer fl ashes.
5-6. Connect the infrared receiver.
5-7. Optional: Information on controlling the X-arm™ bracket using home
automation functions via the RS232 port is located on page 44.
Set
)
00049570bda_Pfade.indd Abs2:30-Abs2:31 00049570bda_Pfade.indd Abs2:30-Abs2:31 13.12.2006 13:24:22 Uhr 13.12.2006 13:24:22 Uhr