12
•
Position the drone directly in front of you so that its
fuselage points away from you and in the desired flight
direction.
•
Hold the remote control such that it points to the rear
part of the drone in a direct line.
•
Launch the drone and fly it at a steady altitude.
•
Press the Actual Direction mode button (7) during the
flight to activate the Actual Direction mode.
•
The Actual Direction mode is confirmed through two
signal tones and fast flashing of the drone’s LED
indicator (5).
•
If you press the Actual Direction mode button (7) again,
the mode is deactivated. A signal tone will sound and
the LED indicator (5) of the drone is now constantly lit.
7.5 Speed levels
Note
•
When you switch on the product, the drone is in low
speed mode.
•
Experienced pilots can increase the drone’s speed by
setting the top speed mode.
•
Press the [H] button (3) to increase the drone’s speed to
the highest speed.
•
Two signal tones confirm the highest setting.
•
Press the [L] button (5) to limit the drone’s speed to the
lowest speed.
•
A signal tone confirms the lowest setting.
7.6 Changing the rotor blades
•
Undo the screw of the rotor blade with the included
screwdriver.
•
Remove the existing rotor blade.
•
Place the new rotor blade on the motor shaft. Make
sure that the rotor blades are mounted as shown in
the diagram, as otherwise the rotation direction will
not be correct and no drive is generated.
•
Secure the rotor blade using the included screwdriver.
1
A2
B1
B2
A1
3
2
4
7.7 Switching off the drone
•
Land the drone.
•
Move the slide switch (7) on the drone to the OFF
position.
•
Press the on/off switch (12) to switch off the remote
control.
Summary of Contents for 00 126851
Page 2: ......
Page 3: ...1 8 1 3 4 6 10 11 11 2 5 2 12 9 3 3 6 7 5 10 7 4 13...
