HF
multi-mode transceiver
KN920
operation manual
(MCU v02.02)
Ham radio products www.bh3mde.com
Email:[email protected]
- 10 -14
When the display character SPF when, KN920-frequency transceiver is not in
working condition.
When you enable the different frequency transceiver function, KN920 will
automatically PTT / CW reception and transmission control switching frequency.
When the current job in the VFO-A, press the PTT / CW, KN920 will automatically
switch to VFO-B transmitter;
When the current job in the VFO-B, press the PTT / CW, KN920 will automatically
switch to VFO-A emission;
When the current in the VFO-A launch, release PTT / CW, KN920 will
automatically switch to VFO-B receiver;
When the current in the VFO-B launch, release PTT / CW, KN920 will
automatically switch to VFO-A receiver;
Note:
As KN920 launch low-pass is to use relay control, so I do not recommend that
users use two different bands on different frequency transceiver functions.
When using automatic key feature when working different frequency if needed,
please confirm the two VFO mode of operation is CW.
Use automatic key function
KN920 includes automatic key , auto key in accordance with the standard 1:3 ratio to issue the
corresponding dots and dashes .KN920 automatic key functions used in two modes
One is the relatively early automatic key way , each time you press a button , it will automatically
send a corresponding signal point plan , if quick succession press any key , it will automatically
send key operation too late to order saved, and then in turn send signals corresponding point plan .
In this mode, press and hold a key down will only be sent once the signal . This model KN920 is
defined as KEYER-NORMAL mode.
Another automatic key way is to hold down a key, the KN920 will send this key represents a
continuous signal when it is released it will stop sending . In this way many times for a quick press
also has a memory function , it will be too late to automatically send key operation saved, then
turn sent. This mode is defined as KN920 KEYER_FAST mode.
To use KN920 automatic key function , you need to follow the following steps:
Repeatedly press the DIS button to adjust the second line of the LCD display characters shown
below
；
