2
Installing
a
SIM
Card
You will need a full-size SIM card with SMS and internet services enabled. To connect to an
Illuminator remotely to add users, change PINs etc., obtain a SIM card on a post-paid plan
from Telstra and request that a
dynamic public IP address
added to you SIM. Simply
advise Telstra to set the following parameters on your SIM: 'GPTEXB3' and 'GPCORPB3'
1. Put the SIM card in a standard mobile phone and disable any PINs.
2. Unscrew the modem access cover located on the top of the Illuminator case,
next to the antenna connector.
3. Look at the SIM slot and ensure the black locking lever is in the unlocked (left)
position. A small flat screwdriver is useful. Very little force is required.
4. Gently push the SIM card into the slot so that it is level with the locking lever,
notch-first and contacts-up. The last few mm is spring-loaded and you will feel
it click into place.
5. Gently slide the black locking lever to the right until it clicks.
6. Screw the modem access cover
Guide
Locking Lever
SIM Slot
Unlocked position
Locked (working) position
Please refer to Appendix C “ Connection to Mobile Network” in the User Manual.
3
Connecting
the
Antenna
and
Power
1. Connect the antenna to the jack next to the SIM card holder– finger tight only
2. Connect Power or Solar Panel and Battery using the supplied connectors to
the CHG and BAT terminals respectively.
Connecting
Controls
Using the connectors provided - connect Controls as per manual
You must use external isolation relays as the inbuilt controls cannot
switch mains power. Use supplied protection diodes on the external
isolation relays.
Connecting
Inputs
(Optional)
Using supplied connectors, connect Inputs as per manual
Switch, pulse and event inputs - connected directly
4-20mA – connect supplied 120 Ohm resistor across input
Voltage inputs – connected via dividing resistors (not supplied)
If metering is enabled, the input number and control number used for the
electricity meter and contactor respectively must match.
Connecting
the
Illuminator
to
your
PC
1. Make sure that your PC is not connected to the Illuminator
2. Turn Illuminator on by pressing the button and holding it till the LCD
backlighting turns on
IMPORTANT
: the backlighting must be ON before a connection can be made
3. Using the supplied red LAN crossover cable connect your PC to the
Illuminator
Please refer to "Physical Connections” in the User Manual for detailed information.
Please refer to "Physical Connections” in the User Manual for detailed information.
Please refer to "Physical Connections” in the User Manual for detailed information.
