Page 4
Due to continuous product research and development,
the information contained herein is subject to change without notice.
www.stoddart.com.au
www.stoddart.co.nz
Attention
General Information
Carefully read this instruction booklet, as it contains important advice for safe installation, operation and maintenance�
This manual is to be passed onto the owner/facility at the project completion�
• All units MUST be installed according to the procedures stated in the installation section of this manual
• In the case of new personnel, training is to be provided before operating the equipment
• DO NOT use this unit for any other purpose than its intended use
• Keep fingers out of “pinch point” areas
• Only use this unit with voltage specified on the rating label
• Threaded fasteners can loosen in service� Regular inspection and tightening should be carried out as required
• If any fault is detected, refer to the troubleshooting guide
When using any electrical unit, safety precautions must always be observed�
Our units have been designed for high performance�
Read these instructions carefully and retain for future reference�
The manufacturer and distributor cannot be held responsible or liable for any injuries or damages of any kind occurred to persons,
units or others, due to
abuse and misuse
of this unit in regards to installation, removal, operation, servicing or maintenance, or lack of
conformity with the instructions indicated in this documentation�
Disclaimer
All units made by the manufacturer are assembled, where possible, and ready to install� Any installation, removal, servicing, maintenance
and access or removal of any parts, panels or safety barriers that is not permitted, does not comply in accordance to this documentation,
or not performed by a
trained and authorised specialist
will result in the
immediate loss of the warranty.
The manufacturer cannot be held responsible or liable for any
unauthorized modifications
or repairs� All modifications or repairs must
be approved by the manufacturer in writing before initiating� All modifications or repairs performed to this unit
must
be performed at all
times by a
trained and authorised specialist
�
Introduction
