Supplied By www.heating spares.co Tel. 0161 620 6677
2
2000225068C
CONTENTS
DESCRIPTION SECTION
PAGE No.
INSTRUCTIONS
FOR USE
INSTALLATION
INSTRUCTIONS
SERVICING
INSTRUCTIONS
Important information
2
Operating the Boiler
4
General Information
1
5
Water System
2
7
Boiler Location and Ventilation
3
10
Flue Location and Ventilation
4
11
Installation Preparation
5
13
Boiler Fixing
6
14
Gas, Water and Condensate Conns.
7
15
Flue Preparation and Installation
8
16
Electrical Connections
9
18
Commissioning
10
20
Servicing
11
21
Fault Finding
12
25
Replacement of Parts
13
27
Spare Parts
14
32
General
This boiler is designed to provide central heating from a fully
pumped open-vented or sealed water system with a fully
indirect cylinder.
The central heating water temperature can be adjusted on the
boiler.
Once the controls are set the boiler operates automatically.
A frost protection program is also included.
Please read these instructions and follow them carefully for the
correct and economical use of your boiler.
Gas Category
This boiler is for use only on Natural gas (G20).
Gas Safety (Installation and Use) Regulations
In your own interests and that of safety, it is the Law that ALL
gas appliances are installed by a competent person in
accordance with the current issue of the above regulations.
Gas Testing and Certification
The boiler is tested and certificated for safety and performance.
It is, therefore, important that no alteration is made to the boiler
unless approved, in writing, by Halstead Boilers Ltd.
Any alteration not approved by Halstead Boilers Ltd., could
invalidate the certification, boiler warranty and may also infringe
the current issue of the statutory requirements.
CE Mark
This boiler meets the requirements of Statutory Instrument, No.
3083 The Boiler (Efficiency) Regulations, and therefore is
deemed to meet the requirements of Directive 92/42/EEC on
the efficiency requirements for new hot water boilers fired with
liquid or gaseous fuels.
Type test for purposes of Regulation 5 certified by: Notified body
0086.
Product/production certified by: Notified body 0086.
The CE mark on this appliance shows compliance with:
1. Directive 90/396/EEC on the approximation of the laws of the
Member States relating to appliances burning gaseous fuels.
2. Directive 73/23/EEC on the harmonisation of the Laws of the
Member States relating to electrical equipment designed for
use within certain voltage limits.
3. Directive 89/336/EEC on the approximation of the Laws of
the Member States relating to electromagnetic compatibility.
Control of Substances Hazardous to Health
Under Section 6 of The Health and Safety at Work Act 1974, we
are required to provide information on substances hazardous to
health.
The adhesives and sealants used in this appliance are cured
and give no known hazard in this state.
Insulation Pads
These can cause irritation to skin, eyes and the respiratory tract.
If you have a history of skin complaint you may be susceptible
to irritation. High dust levels are usual only if the material is
broken.
Normal handling should not cause discomfort, but follow normal
good hygiene and wash your hands before eating, drinking or
going to the lavatory.
If you do suffer irritation to the eyes or severe irritation to the skin
seek medical attention.
Spare Parts
REMEMBER, When replacing a part on this appliance, use only
spare parts that you can be assured conform to the safety and
performance specification that we require. Do not use
reconditioned or copy parts that have not been clearly authorised
by Halstead Boilers Ltd.
Manual Handling Guidance
During the appliance installation and the replacement of the
heat exchanger it will be necessary to employ caution and
assistance whilst lifting as the appliance or component exceeds
the recommended weight for a one man lift.
In certain situations it may be required to use a mechanical
handling aid.
Take care to avoid trip hazards, slippery or wet surfaces.
Important Information
