12
• Use Halo 2-Zone Countertop Griddle as purchased.
• Use Halo 2-Zone Countertop Griddle installation must conform with
local codes, or in the absence of local codes, with either the National
Fuel Gas Code, ANSI Z223.1/ NFPA 54, Natural Gas and Propane
Installation Code, CSA B149.1, or Propane Storage and Handling Code,
B149.2, or the Standard for Recreational Vehicles, ANSI A 119.2/NFPA
1192, and CSA Z240 RV Series, Recreational Vehicle Code, as applicable.
• Use Halo 2-Zone Countertop Griddle is not for use in or on recreational
vehicles and/or boats.
•
Halo 2-Zone Countertop Griddle is safety certified for the United States
use only. Do not modify for use in any other countries. Alteration will
result in a safety hazard.
• The pressure regulator supplied with the appliance must be used.
Replacement pressure regulators
Part # HZ-1004-28
for 1 lb. cylinder
or
HZ-1007-25
for 20 lb. cylinder must be used with the appliance.
• Place dust cap on cylinder valve outlet whenever the cylinder is not in
use. Only install the type of dust capon the cylinder valve outlet that
is provided with the cylinder valve. Other types of caps or plugs may
result in leakage of propane.
INSTALLATION SAFETY PROTECTIONS
• Keep appliance area clear and free from combustible materials,
gasoline and other flammable vapors and liquids.
•
Do not obstruct the flow of combustion and ventilation air flow.
• Keep the ventilation opening of the cylinder enclosure free and clear
from debris.
•
Visually check burner flames.
• Clean appliance, including special surfaces, with recommended
cleaning agents, if necessary.
• Check and clean burner/venturi tube for insects and insect nests. A
clogged tube can lead to a fire beneath the appliance.
SAFETY MAINTENANCE
Turn
OFF
Halo 2-Zone Countertop Griddle when not in use.
• Never move Halo 2-Zone Countertop Griddle while in operation or still
hot.
• Use long-handled barbecue utensils and oven mitts to avoid burns and
grease splatters.
• Keep unit minimum of 36” away from walls, buildings, vehicles or other
structures while in use.
USE AND CARE
• Clean Halo 2-Zone Countertop Griddle after each cookout.
• Turn off gas supply, If you notice grease dripping onto the valve or
regulator. Determine the cause, correct it, then clean and check valve,
hose and regulator before continuing to operate Halo 2-Zone
• Countertop Griddle.
• Keep ventilation openings in cylinder enclosure free and clear of debris.
• The regulator may make a humming or whistling noise during
operation. This will not affect safety or use of Halo 2-Zone Countertop
Griddle .
• Turn off Halo 2-Zone Countertop Griddle immediately, If the regulator
frosts,. This indicates a problem with the LP cylinder, and it should not
be used on any product. Return to supplier.
• Please call customer support at 1-833-572-1688, If you have a problem
with your Halo 2-Zone Countertop Griddle refer to the Troubleshooting
Section on page 25.
IMPORTANT:
•
To check valve, first push in the control knob then release, the control
knob should spring back. If the control knob does not spring back,
replace valve assembly before using Halo 2-Zone Countertop Griddle .
• Push and turn the control knob counterclockwise to low position then
turn back to OFF position. The valve should rotate smoothly.
CHECK CONTROL VALVE CONDITION
Turn the control knob on Right Zone to ignite the burner. Press the
electronic ignition button for 2-3 seconds. You will hear it click then turn
to Dual Zone to lite both burner zones, Turn knob from high to low. You
should see a smaller flame in low position than seen on high. Always check
flame prior to each use. If only low flame is seen refer to “Sudden drop or
low flame” in the Troubleshooting section on page 25.
BURNER FLAME CHECK
• Plastic components:
Do not use Cortisol, abrasive cleaners, degreasers
or a concentrated oven cleaner on plastic parts that could cause a
damage. Wash with warm soapy water and wipe dry.
• Painted surfaces:
Wash with mild detergent or nonabrasive cleaner
and warm soapy water. Wipe dry with a soft nonabrasive cloth. Do not
use abrasive pad on areas with graphics. The grease deposits or baked
on grease may require the use of an abrasive plastic cleaning pad. Do
not apply a corrosive oven cleaner to painted surfaces.
GENERAL CLEANING
