MAN1544-5
11
2.6.2
Zone Indicators
There are two indicators for each alarm zone fitted to the panel.
Zone Alarm
–
Red The indicators show individual zone/s in alarm. On alarm the LED will flash until the
alarm is acknowledged. Once acknowledged the LED will be continuously illuminated until the panel is
reset.
Zone Fault / Isolate
–
Amber
Illuminated by:
A fault condition on an individual zone (flashing);
Isolating a zone/s, illuminated steady unless in fault, then flashes.
A zone in fault that has already been isolated flashes at a different rate than when only in fault, the off
period is the same with the on period being 3 times that of the fault flash rate.
2.7
Liquid Crystal Display
The panel is fitted with an 8 x 2 LCD. Its primary purpose is to display Zone alarm / fault / isolate
information and prompts for system commands come programming. Alarm, Fault and Isolate information is
accessed through the Main Menu. When the FACP is in its normal state a default screen will be displayed.
Examples of LCD Displays are;
AMPAC
MON 12 : 58
F1 / 2
BATTERY
F1 / 1
CHARGER
Default Screen
Fault 1 off 2 Battery Fault
Fault 1 off 1 Charger or Power Fault
Note:
Some of the following sub-menus will not be available if the facility has not been installed, eg.
Brigade, Relays, Fire Fan, Agent Release, Sounder, and / or Input boards / cards / modules. If one of the
above ancillary facilities has been fitted retrospectively it must be appropriately programmed into the FACP
via the SYSTEM and PROGRAM MENUS, if not a System Fault will be indicated. Once programmed into the
FACP the ancillary facility is monitored in the normal way. Refer to the SYSTEM and PROGRAM MENU
structure diagrams in the Appendix for more information.
Press
ENTER
to access
MAIN MENU
