Hally-Gally 20.02.116, Assembly Instructions Manual, Page: 15 / 29

SPOGG Sport-Güter GmbH
•
Schulstr. 27
•
35614 Aßlar/Berghausen
spogg@hally-gally-spielplatzgeraete.de
•
www.hally-gally-spielplatzgeraete.de
T:\PLAY\Play Installation Instructions\Installation Instructions 2012-2013\20_02_116-01-en-000.doc - 15 -
A.z.Ar. Excavate.1,40 m x 1,40 m =
Trampoline/Foundation frame (1,25 m x 1,25 m)
G Drainage layer
O.K. Top-ground surface
PS Required space including safety zone
S: A - A View: A - A
TF ! Parting line 1 cm around the Trampoline / (shown in orange in
diagrams) !!
WH-Bor !
Connect trampoline to foundation frame
Zus.F.Pl. Provided upon request!
Wet pour tiles placed around trampoline
T.anh. ! Lifting trampoline to install or clean!
(1. Trampoline in natural ground surfacing)
Installing:
View A.z.Ar.
When lifting or lowering the trampoline pay attention that it is equally
lifted on all 4 outer corners!
The Trampoline must be installed evenly onto the foundation.
Cleaning:
After excavating the area on the folding hinge side has been done,
proceed as followed:
Lot ! OK.-
Tr. Upper edge of Trampoline:
Install equally level.
Lot ! OK.-
FER./SER. Upper edge of foundation:
Install equally level.
TAM
Trampoline outer measurements
Pay attention that the parting line/joint is kept clean!
Styrofoam Place 1cm thick styrofoam in the area around the trampoline (max.
height of the styrofoam is the lower edge of outer rubber surfacing
on top of the trampoline!)
(view diagram)
Sand
(Granulat)
Fill the parting line/joint with sand or granulate!
(view diagram)