Flat wooden
stick
Push
Warm up roof vent seal (
138
) to approximately room temperature.
Working on a flat surface, cap the bottom edge of glass with roof vent seal (
138
), being careful not to stretch seal.
Fit roof vent bottom bar centrally over the glass,
knock
down
gently with a wooden, rubber or hide mallet
with the
glass held vertically, supporting the free edge on a wooden block as in
A
.
REMEMBER, GLASS IS FRAGILE, HAND WITH CARE USING GLOVES.
Using a sharp knife, make a cut into the glazing seal, slightly back from the corner of the glass as in
B
.
Cap both sides of the glass with the seal, ensuring cut in seals fits over the corner of the glass as in
C
.
Fit left and right roof vent bars over the glass and fix corners to roof vent bottom bar using self-tapping screws
(
1106
). Please see main instructions. Cut the seal slightly back from the corners as before and cap top edge of
glass, cutting seal so that it butts together in the centre of the roof vent bar as in
fig. 9
.
Fit roof vent bar over glass and assemble corners using self-tapping screws (
1106
) a before.
Check diagonal measurements for squareness.
Adjust if necessary and tighten screws.
Bed gaskets down onto frame using a flat wooden stick as in
D
.
Apply small amount of silicone sealant (
37
) to each corner.
See main instructions for fitting of vent to building.
TOP
TOP
TOP
21
1106
Summary of Contents for SILVERLINE 86 LEAN TO
