Assembly Instructions (All Models)
Tools Required: 3/8” nut driver, slotted screwdriver, rubber mallet.
Do NOT fully tighten bolts until cabinet is completely assembled.
1. Place rear panel (item 5) on either padded horses or on protected floor with flanges
upward.
2. Attach side panels (items 7) with the flange under the rear panel offset with 10-24x3/8”
bolts and nuts. The bottom support strips should be at the same end and shelf
adjustment strips pointed in the same direction.
3. Place a shelf (item 8) into shelf adjustment strips to hold sides in upright position while
attach top (item 6).
4. Place door frame assembly (items 1, 2, 3) on top of assembly and bolt to top and side
panels.
5. Position bottom (item 4) into offset support strips on sides and rear. Front flange of
bottom must fit over front flange of frame and be bolted with 2 bolts for the outside
(tighten).
6. If model 455/465/855/865, install center divider (item 11 fig. 3) tighten bolt to bottom.
7. Bolt (4) cabinet foot plates (items 13) to frame and sides and rear (tighten). All models.
Skip this step for mobile cabinets.
8. Stand cabinet upright, be sure cabinet is level and doors close properly and then
tighten all bolts.
9. Insert one side of adjustable shelf (item 8 or 12) at desired position then move other
side up to the same position. If model 435/445/835/845, bolt one coat rod holder (item
10B) inside the flange of shelf with bolt heads outward. Slide rod (item 9 or 10A) into
place, place second rod holder on opposite end of rod and then bolt second rod holder
to shelf. Insert in top location. Seat all shelves with mallet.
10. Using rubber mallet, tap nylon rod guide (item 15) into top and bottom flanges of right
door (item 2).
11. Install turn handle (item 14) to right door with #8-32 bolts (item 19) through handle plate
(item 21) – reference door handle detail. Place lock cam (item 17) on back of handle
with pins out. Insert lock rods (item 16) into rod guides and position holes in lock rods
on pins of lock cam. Secure in place with cam keeper (item 18) using hitch pin clip
(item 20).
12. For mobile cabinets only, attach two casters to each of two caster plates and then
attach caster plates to cabinet bottom (see Caster Kit detail).