19
Error Codes
When some malfunctions come on, the appliance will display error codes to warn you:
Codes
E1
E4
Ed
E8
Meanings
Longer inlet time.
Water overflow into motor compartment.
Signal error between the control board
and the unit.
Failure of orientation of distribution valve.
Possible Causes
Faucet is not opened, water intake is
restricted, or water pressure is too low.
Check to assure the machine is level.
Verify the level of detergent used. Defective micro-switch
or drain pump.
If this occurs repeatedly, call a servicer or your dealer.
Open circuit or break of distribution valve.
E9
Contact with a control button for more than
30 seconds.
Water or other substance/object on the control buttons.
If overflow occurs, turn off the main water
supply before calling a service.
If there is water in the base pan because of
an overfill or small leak, the water should be
removed before restarting the dishwasher.
WARNING
Read the installation instructions clearly, and futher more,
pay attention to the follow lists:
1.the power-supply receptacle for the appliance shall
be installed in a cabinet or on a wall adjacent to the
under counter space in which the appliance is to be installed.
2.there shall be an opening through the partition between the
compartments specified in (a) that is large enough for the
attachment plug to pass through. The longest dimension of
the opening shall not be more than 38 mm (1.5 in).
3.the edges of the opening specified in (b) shall, if the partition
is wood, be smooth and rounded, or, if the partition is metal,
be covered with an edge protector provided for this purpose
by the manufacturer.
4.care shall be exercised, when the appliance is installed or
removed, to reduce the likelihood of damage to the
power-supply cord.
NOTE: A hose that attaches to a sink spray can burst
if it is installed on the same water line as the dishwasher.
If your sink has one, it is recommended that the hose be
disconnected and the hole plugged.
INSTALLATION INSTRUCTION S
