4
VGA-over-UTP
3.0
Setup and Operation
A.
Place the sender near the video source and connect it to your
source using the cable provided.
•
For PC’s VGA output use a HD15 male-to-male cable (generally a
short cable may be included with your package)
•
For RGB or YPbPr sources, use a HD15 to 3 RCA cable (Hall
Research Model # CHD15-3RCA-length 03 = 3ft, 06 = 6 ft).
B.
Use an Unshielded Twisted Pair (UTP) or a Shielded Twisted pair
(STP) cable such as Cat5, 5e, or 6 wired per standard 568B to
connect the sender to the receiver(s). See Section 3.1 for important
cable selection considerations.
IMPORTANT
Do not connect this unit to any LAN device such as network cards or hubs as
this may cause damage. Use EIA/TIA 568B standard straight-through patch
wiring as shown below. Do not use crossover cables.
EIA/TIA 568B WIRING STANDARD
PIN
Wire Color
1
White w/ Orange Stripe
2 Orange
3
White w/Green Stripe
4 Blue
5
White w/Blue Stripe
6 Green
7
White w/Brown Stripe
8 Brown
C.
At each remote site connect a receiver (UV1-R and UV1-R-WP) to
the Cat5 cable and plug your display to its HD15 output connector.
D.
Plug a power supply to the System based on the type of the sender
used.
Figure 2
