ECHO Family
8
© Copyright 2020 Hall Research, LLC.
Model
ECHO-1S (rear)
1 2 3 4 5 6
1)
RS-232: Connect to an RS-232 controller using the Phoenix terminal to
transmit RS-232 commands.
2)
EDID: 3-position switch to control EDID routing.
a.
Local: Use EDID from display connected to HDMI OUT port.
b.
EMUL: Use internal emulated EDID.
c.
Remote: Use EDID from display connected to receiver.
3)
HDBaseT Out: Connect CAT5e or CAT6 cable to receiver.
4)
RST: Reset switch. Hold 3 seconds to reset the unit to factory defaults.
5)
FW: USB Micro port used to update firmware.
6)
Audio Out: Line level stereo analog audio, de-embedded from HDMI IN.
Model
ECHO
-4S (front)
1 2 3 4
1)
Status LEDs: POWER indicates sender power. PoC indicates the 24 V
Power over Cable is being used. HDMI IN indicates an HDMI signal is
detected.
2)
RST: Reset switch. Hold 3 seconds to reset to the unit to factory
defaults.
3)
EDID: 3-position switch to control EDID routing.
a.
Local: Use EDID from display connected to HDMI OUT port.
b.
EMUL: Use internal emulated EDID.
c.
Remote: Use EDID from display connected to receiver.
4)
FW: USB Micro port used to update firmware.
