SingleCell v1.0- Instruction manual
3
Precautionary Statements
Tips
• Don’t remove the protective film on the acrylic panels until after installation. Instead,
peel away an inch or so (25mm) from the edges so you can handle them without getting
them dirty. Once installed peel away the rest of the film.
• Make sure to hammer in the corner connectors straight otherwise the enclosure will be
out of square and will require manual correction.
• Do not overtighten screws! Acrylic can crack especially under the pressure of a screw
head. Always use the Washer_v1 with screws when instructed.
• We recommend printing the 3D printable files beforehand.
• All 3D/FFF files can be found here https://www.hall-precision.com/downloads
CHOKING HAZARD—Small parts
Not for children under 12 yrs�
SHARP EDGES— Components may
have sharp edges�
Not for children under 12 yrs�
WARNING
WARNING
0-12
Tools Needed
1. Soft hammer/mallet
2. Number 2 Phillips Screwdriver (The one you received with your Prusa will work)
3. Steady surface such as a concrete floor or workbench
4. Utility knife/razor blade
Introduction