EB+ CAN Hub
Installation
Guide
16
Innovative Vehicle Solutions
2020
Chassis installation
The EB+ CAN Hub ECU will be fitted directly to the trailer chassis using the three holes with compression limiters.
The mounting fixing must provide an electrical connection between EB+ CAN Hub ECU and vehicle chassis.
Ground level
Deck of trailer
Position the EB+ CAN Hub assembly as high as possible
in the chassis to provide as much protection to the
assembly from direct spray, other road debris.
Pitch angle: assembly must be mounted vertically.
The mounting bracket flatness is to be not more than
0.5 mm deviation from its true plane i.e. the surface
must lie between two parallel planes 0.5 mm apart.
Check the earth continuity between EB+ CAN Hub ECU
and the vehicle chassis.
Resistance (R) to be less than 5 ohms
0 < R < 5 ohms
Secure the EB+ CAN Hub using bolts, flat washers and
noncorrosive self locking nuts.
Recommended fixing screw thread size M6 x 1.0
30 mm long (3 off) with 20.5 dia minimum washers,
locking torque 5.5 / 6.0 Nm.
The EB+ CAN Hub mounting parts (i.e. bolts, washers
and locking nuts etc) are to be protected from
corrosion to give 200 hours salt spray resistance.
Fixing
0
-
5
Ω
