11
Starting Up
2
Starting Up
2.1
Unpacking and assembling
Open the box, two people are required
to remove the machine from the protec-
tive foil and place it on the floor.
1. Fix the side brush (Fig. 2/1) to the
axle of the side brush drive using the
wing bolt and washer supplied.
2. Loosen the two knurled screws (Fig.
2/2) holding the handle a few revolu-
tions until the handle can be raised
and positioned. Set the handle to a
height comfortable for the user and
then tighten the knurled screws.
3. Loosen the locking bolt holding the
hood (Fig. 2/3) and pivot the hood
open.
4. Fix the disassembled cable lug (Fig.
2/4) to the corresponding battery
contact. It is possible that sparking
will occur when connecting the bat-
teries!
5. Close the hood and lock in place with
the bolt.
6. The Sweepmaster B500 is now
ready to operate.
Fig.2
2.2
Instruction
Instructions to operators are required
before putting the machine into service.
Only technicians from your local, autho-
rized Hako dealer are allowed to pro-
vide initial instruction on how to use the
machine. The manufacturing plant noti-
fies the dealer immediately after deliv-
ering the machine and the dealer will
contact you to arrange a date for provid-
ing the initial instruction.
2.3
Initial battery charge
Before starting the machine up
for the first time, the batteries
to be used must be fully
charged, properly, by imple-
menting the initial battery
charge routine. Hako assumes
no liability for damage to the
battery caused by a fault when
the battery is charged for the
first time.
4
1
2
3
