Haklift Oy
Asessorinkatu 3-7
20780 Kaarina, Finland
Tel. +358 2 511 5511
www.haklift.com
Lifting Solutions Group
Axel Johnson International
OPERATING
Scope of use
This hydraulic jack is intended to lift objects temporarily and not for long term hold. The object needs to be
secured by jack stands as soon as the object reached the desired lifting height. No one should be allowed
under the load before it has been secured. When using this jack, it shall be put on a fixed and solid surface,
such as reinforced concrete floor.
Figure 1
Method of operating
Lifting
Place the load on the toe plate or on the head plate of the jack. Note that the toe lifting capacity is lower than
the head capacity.
ATTENTION:
The load must be on the full area of the plate (see figure 1).
IMPORTANT POINT:
The load should be centered to the centerline to avoid deformations. Tighten the unload
handle (16) tightly before lifting. Then press and lift the operating handle up and down repeatedly to pump the
pressure to lift the load. The lifting movement can be stopped immediately by stopping the pumping action.
Lowering / Reducing
Rotate the unload handle slowly in counter-clockwise direction to descend the load step by step. When
tightening the unload handle again, the descend movement can be stopped instantly.
NOTE:
When the jack is in unloaded condition, the head of it should be pressed down to retract completely.
ATTENTION:
The only part allowed to be removed by the user is the pump handle (2). The maintenance and
repairs must be performed by authorized personnel.
SAFETY STANDARD
Lifting a load is a dangerous operation, so the appointed operators should be professional, trained and
experienced.
To avoid accidents, extra weights must not be added on the lifted load.
Never exceed the maximum capacity of the jack.
Keep a safe distance to the lifted load.