Hakko Electronics Monitouch V Series, Reference Manual

Page: 47 / 746

Chapter 1 System Setting
1-10
♦
[Write Area] ([Main 1] tab window)
This is the area where data is written from [Read Area], such as the displayed
screen number, overlap display status, buzzer sounding status, etc. 3 words of
consecutive memory addresses are secured. MONITOUCH writes information
to these 3 words during communications with the PLC.
Memory addresses are allocated as shown below.
[Write Area] “n” (output of [Read Area] “n”)
When the V Series has completed a display operation, sub command/data in
[Read Area] “n” is written into the PLC.
POWER
F1
F2
F3
F4
F5
F6
F7
SYSTEM
. . .
. . .
. . .
. . .
. . .
. . .
. . .
. . .
. . .
. . .
. . .
. . .
. . .
. . .
. . .
. . .
RUN
STOP
Monitoring
A-1 A-2 A-3 A-4 A-5
B-1 B-2 B-3 B-4 B-5
C-1 C-2 C-3 C-4 C-5
D-1 D-2 D-3 D-4 D-5
POWER
F1
F2
F3
F4
F5
F6
F7
SYSTEM
Backlight OFF!
(The unit status is set to the write area.)
The backlight goes off when the screen
is not touched for a certain time.
Address Name Contents Operation
Write area = n CFMDAT Same as data in read area “n” V series
→
PLC
n + 1 SCRN_COM Screen status V series
→
PLC
n + 2 SCRN_No Displayed screen number V series
→
PLC
Data in these memory addresses is saved at $s464 to 466 of the V series internal
memory. For more information on the internal memory ($s), refer to “Appendix 1
Internal Memory.”
BZ0
Free
BZ1
System reserved (setting [0])
Calendar setting
System reserved (setting [0])
15 14 13 12 11 10 09 08 07 06 05 04 03 02 01 00
0 0 0 0 0 0 0 0 0 0 0 0 0