Hakko Electronics Matala HK-25L, Manual, Page: 19 / 20

13) Screw the 4 screws in just a little at a time while gradually increasing the torque. Progress around the screws
gradually tightening evenly until both halves are fully connected and tight with the motor plate.
14 ) Replace the black J-Tube over the diaphragm outlet. Use existing clip to secure tube to outlet.
Repeat these instructions for the second diaphragm starting at #6.
15 ) After both diaphragms have been replaced, put the white sound absorber back over the motor. Tap it
clean if it is dusty. Do not wash.
16 ) Replace the outer metal housing onto the base and tighten the 4 screws. Wash the square air filter with tap
water and shake dry. Reinstall into the top of metal housing and replace the filter cover. Congratulations,
you’ve done it!
18