CAUTION
WARNING
To prevent accidents or damage to the HAKKO FX-100, be sure to observe the following:
When power is ON, the tip will be hot. To avoid injury or damage to personnel and
items in the work area, observe the following:
Do not touch the tip or the metal parts near the tip.
Do not allow the tip to come close to, or touch, flammable materials.
Inform others in the area that the unit is hot and should not be touched.
Turn the power off when not in use, or left unattended.
Turn the power off when changing parts or storing the HAKKO FX-100.
The unit is for a counter or workbench use only.
This appliance can be used by children aged from 8 years
and above and persons with reduced physical, sensory or
mental capabilities or lack of experience and knowledge if
they have been given supervision or instruction concerning
use of the appliance in safe way and understand the hazards
involved.
Children shall not play with the appliance.
Cleaning and user maintenance shall not be made by
children without supervision.
Do not use the HAKKO FX-100 for applications other than soldering.
Do not allow the HAKKO FX-100 to become wet, or use it when hands are wet.
Do not modify the HAKKO FX-100.
Use only genuine HAKKO replacement parts.
Be sure to hold the plug when inserting or removing the iron cord.
Do not strike the iron against hard objects to remove excess solder. This will damage
the iron.
Be sure the work area is well ventilated. Soldering produces smoke.
While using the HAKKO FX-100, don't do anything which may cause bodily harm or
physical damage.
3. WARNINGS, CAUTIONS AND NOTES
Warnings, cautions and notes are placed at critical points in this manual to direct the operator’s
attention to significant items. They are defined as follows:
CAUTION :
Failure to comply with a CAUTION may result in injury to the operator, or damage to the
items involved. Two examples are given below.
WARNING:
Failure to comply with a WARNING may result in serious injury or death.
NOTE :
A NOTE indicates a procedure or point that is important to the process being described.
