6
●カードと温度設定の変更
ハッコー FM-203 の取扱説明書を参照
してください。
●こて先の交換
こて先の取外しと挿入
こて先の取外し:
ハンドルを握り、耐熱パッドを使って
こて先を持ち、こて部から引き抜きま
す。
こて先の挿入:
こて先の先端部分を持ち、止まるとこ
ろまでこて部へ挿入します。
この部分を持ってこて部へ挿入します。
ハンドルの前側部分を持って、
こて先を取り外します。
中 文
English
日本文
注意
こて先は高温になっています。やけどの
原因となりますので、取扱いには十分ご
注意ください。耐熱パッドで熱いこて先
を長時間つかまないでください。
l
Operating instructions
1. Set the Temperature
CAUTION:
Very high tip temperatures may damage
the printed circuit board, possibly causing
the printed pattern to become detached.
HAKKO recommends setting the tip tem-
perature below 300°C for all normal work.
Using the lowest possible effective temper-
ature not only helps protect parts that are
sensitive to heat, it also helps protect the
tip from deterioration caused by heat.
2. Apply solder or flux
If there is insufficient solder on the
PWB, or the soldered area is too small,
apply solder or flux to the PWB. Solder
may also be applied to the tip.
3. Melt the solder
Place the tip on the soldered part and
melt the solder. Confirm that the solder
is fully melted. See sketch ‘A’.
4. Remove the component
After confirming that the solder is fully
melted, lightly squeeze the handpiece
to grasp the component and lift to re-
move the component. See sketch ‘B’.
Component
Solder
A
B
中 文
English
日本文
29
CAUTION:
The tip is very hot during operation.
Do not touch the tip or the metal parts
near the tip.