3. WARNINGS, CAUTIONS AND NOTES
2. SPECIFICATIONS
5. INITIAL SETUP
4. PART NAMES
Thank you for purchasing the HAKKO FG-460 Footwear Tester.
The HAKKO FG-460 is a tester for determining the anti-static performance of safety
shoes while worn by the operator.
The operator needs only to step onto the tester plate
with one’s shoes on and gently press the pad on the tester by hand.
The tester determines whether resistance is within the range specified in JIS T8103 and,
if the pair of shoes is good, displays the range that resistance falls in.
Please read this manual before operating the HAKKO FG-460.
Keep this manual readily accesible for reference.
1. PACKING LIST
Please check to make sure that all items listed
below are included in the package.
HAKKO FG-460 Footwear Tester
Mounting base
AC adapter
Test plate
Mounting screw*
1
1
1
1
2
Pan head screw
Wood screw
Instruction Manual
2
2
1
AC adapter
Test plate
HAKKO FG-460
Footwear Tester
(main unit)
Mounting screw*
Pan head
screw
Wood
screw
Mounting base
* Delivered as they are
screwed onto the tester
main unit.
DC 24 V 33 mA
DC 20 V
1000 MΩ (1 × 10
9
Ω)
100 MΩ (1 × 10
8
Ω)
10 MΩ (1 × 10
7
Ω)
1 MΩ (1 × 10
6
Ω)
0.1 MΩ (1 × 10
5
Ω)
R
＜
0.1 MΩ (1 × 10
5
Ω)
R
＜
0.1 MΩ (1 × 10
5
Ω)
±5
％
±10
％
±8
％
0 to 40℃, max.80% RH, without condensation
120 (W) × 30 (H) × 185 (D) mm (4.7 × 1.2 × 7.3 in.)
0.55 kg (1.2 lb.) (Including mounting base)
Applicable rated pollution degree 2 (According to IEC/UL61010-1)
Upper evaluation limit
Lower evaluation limit
Conductivity evaluation
R
＜
0.1 MΩ
0.1 MΩ
≦
R
≦
100 MΩ
100 MΩ
＜
R
Rating
Measurement Voltage
Measurement
Range (Ω)
Evaluation
level accuracy
Operating environment
Dimensions
Weight
Environmental condition
1.6 m
300 (W) × 30 (H) × 300 (D) mm (11.8 × 1.2 × 11.8 in.)
1.9 kg (4.2 lb.)
Cord length
Dimensions (w/o cord)
Weight (w/o cord)
●
Test plate
DC 24 V
Output voltage
●
AC adapter
* HAKKO offers calibration service for the HAKKO FG-460.
Contact HAKKO for details.
* Specifications and design are subject to change without notice.
Warnings, cautions and notes are placed at critical points in this manual to direct the operator’s
attention to significant items. They are defined as follows:
WARNING: Failure to comply with a WARNING may result in serious injury or death.
CAUTION :
Failure to comply with a CAUTION may result in injury to the operator, or damage
to the items involved.
NOTE :
A NOTE indicates a procedure or point that is important to the process
being described.
●
This appliance can be used by children aged from 8 years and
above and persons with reduced physical, sensory or mental
capabilities or lack of experience and knowledge if they have
been given supervision or instruction concerning use of the
appliance in safe way and understand the hazards involved.
●
Children shall not play with the appliance.
●
Cleaning and user maintenance shall not be made by
children without supervision.
●
Do not wet the product. And, do not perform measurements with wet hands.
●
Do not subject the product to strong impacts. Do not hit or forcefully press the pad.
●
Turn the power off when not in use, or left unattended.
●
Unplug the power cable from its outlet before long periods of disuse.
●
Use only genuine HAKKO replacement parts.
●
Do not modify the HAKKO FG-460.
●
Remove power and iron cords by holding the plug. not the wires.
●
Thick socks can effect anti-static evaluation. Properly wear anti-static shoes as explained
in the instructions provided with the shoes.
●
The mounting base is used when using the optional stand, therefore take good care of it.
●
While using the HAKKO FG-460, don’t do anything which may cause bodily harm or
physical damage.
To prevent electrical shock and damage, observe the following precautions.
Installation holes for
optional stand
Mounting base
Installation holes
for wall mounting
Test plate
(Left foot)
Test plate
(Right foot)
Connecting cable
Power switch
Evaluation result
Level indicators
(Right foot)
Level indicators
(Left foot)
Pass range indicator LEDs
Pad
Power switch
GND terminal
AC adapter jack
Test plate jack
External output terminal*
Connecting cable
Left
Right
UP
UP
UP
2019.5
MA02770XZ190522
The HAKKO FG-460 can be installed on a desk, wall or the optional stand.
— NOTE —
●
Mounting on the wall
1. Install the mounting base as shown in the diagram using the included wood screws or
pan head screws.
2. Place the HAKKO FG-460 on the mounting base and secure it to the base using the included
mounting screws.
3. Plug the connecting cord from the test plate and the AC adapter plug into the respective jacks on
the left side of the HAKKO FG-460.
4. Plug the AC adapter into a wall outlet.
AC adapter
Connecting cable
Toes face the
“UP” sign
1
2
3
* Refer to the “
●
About evaluation
external output
”
© 2016-2019 HAKKO Corporation. All Rights Reserved.
Company and product names are trademarks or registered
trademarks of their respective companies.
OVERSEAS AFFILIATES
U.S.A.: AMERICAN HAKKO PRODUCTS, INC.
TEL: (661) 294-0090 FAX: (661) 294-0096
Toll Free (800)88-HAKKO
4 2 5 5 6
http://www.hakkousa.com
HONG KONG: HAKKO DEVELOPMENT CO., LTD.
TEL: 2811-5588 FAX: 2590-0217
http://www.hakko.com.cn
E-mail:[email protected]
SINGAPORE: HAKKO PRODUCTS PTE LTD.
TEL: 6748-2277 FAX: 6744-0033
http://www.hakko.com.sg
E-mail:[email protected]
Please access to the following address for the other Sales affiliates.
http://www.hakko.com
HEAD OFFICE
4-5, Shiokusa 2-chome, Naniwa-ku, Osaka 556-0024 JAPAN
TEL:+81-6-6561-3225 FAX:+81-6-6561-8466
http://www.hakko.com E-mail:[email protected]
When setting up the test plate, make sure the toes
are facing towards the "UP" sign on the center
divider.
Unplug the power cable from its outlet before long periods of disuse.
When the connecting cable is not fully inserted, it may cause malfunction. Please
make sure that the connecting cable is plugged in properly to the main unit.
WARNING
CAUTION
CAUTION
CAUTION
Instruction Manual
FOOTWEAR TESTER
FG-460
