Hakki Pilke HakkiFeed 422, Manual

Page: 9 / 19

9 / 19
HakkiFeed 422 rev. A Translated Version 1-2019
5.3. Washing and cleaning
Loose debris and sawdust can be cleaned from the machine with pressurised air, for example. The machine
can also be washed with a high-pressure washer as long as the water jet is not aimed directly at the bearings.
Always ensure that the machine and the working area are sufficiently clean during operation. The machine
must always be cleaned after use. Clean the machine at suitable intervals and always before storing the
machine for a prolonged time. After washing, the machine must be lubricated according to the instructions in
Section
5.2 .
6. Storage
Although the machine is intended for outdoor use, it should be covered and stored in a sheltered location or
indoors. Before prolonged storage, the machine must first be cleaned, then washed according to Section 5.8
and lubricated according to Section 5.5.
7. Maintenance table
Target Task Daily Interval
50 t
Interval
200 h
Substance/access
ory item
Lubrication points Lubrication ( Section
5.2 )
X X* Lubrication grease
*bearings
Tightening
bolts (condition,
tightness) Check X
Hoses Check X
8. Failures and remedial measures
Failure Cause Remedial measure
The in-feed conveyor rollers
are not rotating.
1. The feed serial connection
valve is connected to the
machine
2. Quick coupling fault or loose
coupling
3. Incorrect or insufficient valve
pressure
1. Open the valve (Figure
3)
2. Repair connection
3. Contact the retailer
The feeder is not moving 1. Quick coupling fault or loose
coupling
2. Log stuck
1. Repair connection
2. Disconnect
from the
power source and remove
blockage